Publicidad
Idiomas disponibles
Idiomas disponibles
Planning for Non- RIDGID Tools
Other bench top power tools may be
mounted on this legset. However, first
make sure:
• The benchtop power tool does not
weigh more than 300 pounds and is
evenly distributed on the particle board
table top.
General Assembly
Attaching Leveling Feet
1. Locate the following parts and hard-
ware.
8 Hex Jam Nuts, 3/8-16
4 Leveling Feet
4 Lower Legs
2. Thread hex nut to within 1/4 inch of the
bottom of each of the four leveling feet.
3. Install leveling feet through holes in
lower legs as shown. Finger tighten
nuts.
4. Final adjustment and tightening of the
leveling feet will be needed once you
have completed the entire assembly
process.
All manuals and user guides at all-guidesbox.com
• The benchtop power tool is securely
• The combined legstand and attached
If your tool is similar to one of the above,
use that setup configuration.
Hex Jam Nut
8
fastened to the particle board top.
bench top power tool are stable and
will not tip.
Leveling
Foot
3/8-16
Lower Leg
Leveling
Foot
Publicidad
