Publicidad
Idiomas disponibles
Idiomas disponibles
Assembling Upper and Lower
Legs
1. Locate the following parts and hard-
ware:
8 Carriage Bolts 5/16-18 x 5/8"
8 Hex Flanged Nuts 5/16-18
4 Lower Legs (with leveling feet
attached)
4 Upper Legs
2. Position the lower leg inside the upper
leg for the desired height setting.
NOTE: The minimum height of the leg-
stand is 24" and the maximum is 34". The
distance between holes in the lower leg(s)
is approximately 2-1/2". The actual height
setting will depend on the type of tool and
the operator's preference.
3. Place a carriage bolt through only the
bottom hole of the upper leg and then
throught the desired hole in the lower
leg. Finger tighten nut.
All manuals and user guides at all-guidesbox.com
Hex Flanged Nut
9
Carriage Bolts
5/16-18 x 5/8
Upper Leg
5/16-18
Lower Leg w/
Leveling Foot
Publicidad
