Publicidad
Idiomas disponibles
Idiomas disponibles
SYMBOLOGY
Volts
Direct Current
No Load Revolutions per Minute (RPM)
WARNING
Read operator's manual.
Always wear eye protection.
Use appropriate hearing and
respiratory protection.
Do not operate machine
with carrier above line
marked on mast.
Center Hole Indicator Tool
Hole Start Mode
Spindle Rotation ON/OFF
ARM button
Carrier Lock
Carrier Unlock
UL Listing for Canada and U.S.
C
US
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push the battery latch lock
to the side and squeeze the battery latch lever. Pull
the battery pack away from the machine.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body of
the machine. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this machine.
Others may be hazardous.
Attaching Wheel Assembly
1. Remove battery pack.
2. Set the base on the ground upright.
3. Align the bolt with wheel assembly to the back of
the stand, as shown.
4. Insert the bolt through the hole, connecting the
wheel assembly to the base.
5. Tighten the knob securely located on the back of
the wheel assembly.
Risk of Electric Shock
Assembling the Core Drill Stand
Ensure the stand is anchored properly before install-
ing the drill. The stand must be anchored using an
expansion-type anchor, or vacuum pad and pump.
1. Set the base on the ground.
2. Raise the mast upright to
the desired angle.
3. Tighten the angle brace
handle securely.
4. Slide carrier assembly
onto the mast, match-
ing carrier wheels with
grooves in the mast.
NOTE: Over time, the
carrier assembly may be-
come loose and need to
be tightened (see "Adjust-
ing Carrier Assembly" in
the Maintenance section).
5. Press in the feed handle
button and insert the feed
handle into one of the
handle locations. Release
the button. Ensure the
handle clicks into place.
6. Turn the feed handle to
lower or raise the car-
rier. When the carrier
is fully raised, it can be
lifted off of the mast.
WARNING! Do not oper-
ate machine with car-
rier above line marked on
mast. The carrier will be loose or could become un-
secured during coring and possibly cause injury.
ONE-KEY™
To learn more about the ONE-KEY™ functionality for
this machine, go to milwaukeetool.com/One-Key. To
download the ONE-KEY™ app, visit the App Store or
Google Play from your smart device.
ONE-KEY™ Indicator
Solid Blue
Wireless mode is active and ready
to be configured via the ONE-KEY™
app.
Blinking Blue Machine is actively communicating
with the ONE-KEY™ app.
Blinking Red Machine is in security lockout and
can be unlocked by the owner via
the ONE-KEY™ app.
5
Knob Screw
Handle
Angle
Brace
Publicidad
