Makita 4326 Manual De Instrucciones página 9

Aluminum base type
1
2
1. Bolt 2. Fence guide 3. Hex wrench 4. Rip fence
(Guide rule)
2. Circular cuts
2
3
1. Treaded knob 2. Guide facing 3. Rip fence (Guide
rule) 4. Pin
Aluminum base type
4
1. Threaded knob 2. Pin 3. Rip fence (Guide rule)
4. Fence guide
3
4
Steel base type
1
4
1
2
3
Steel base type
1
1. Rip fence (Guide rule)
Aluminum base type
1
1. Rip fence (Guide rule)
When cutting circles or arcs of 170 mm or less in
radius, install the rip fence as follows.
Insert the rip fence into the rectangular hole on the
side of the base with the fence guide facing up.
Insert the circular guide pin through either of the
two holes on the fence guide. Screw the threaded
knob onto the pin to secure the pin.
Now slide the rip fence to the desired cutting
radius, and tighten the bolt to secure it in place.
Then move the base all the way forward.
NOTE:
• Always use blades No. B-17, B-18, B-26 or B-27
when cutting circles or arcs.
Anti-splintering device for steel
base (optional accessory)
1
► 1. Anti-splintering device 2. Protrusions
9 ENGLISH
2