Tecfrigo Snelle 400 BTV Instalación Y Uso página 7

3 . Ensure that there is no danger of explosion (AD) in the room. . The connecting cable to the appliance
is H05 VVF, designed for internal use. . Connect the plug (do not use three-way adapters and reduction
N.B.
adapters). If during transport or storage the appliance has been placed by mistake in a horizontal
position or has been turned upside down, leave for at least three hours in the correct position before
switching on the power supply (see figure 3).
6. CONTROLS
The controls of the appliance are situated at the front inside a protected rectangular recess. . 1 Light
switch: to switch on the light inside the appliance. 2 Refrigeration unit switch:
3 Thermometer:
system . to read the temperature inside the appliance.
temperature inside the appliance. In order to adjust the temperature: pushing once the button 4 "SET"
the display will show the temperature of the cell, pushing several times the button
temperature increases while pushing several times the button
TOUCH: 1. Light :
to switch on the light inside the display cabinet.
refrigeration system. 3. M anual defrosting.
Thermostat:
to adjust the temperature in the appliance.
temperature set-point, which can be changed by pressing button
conservation: enable / disable the energy conservation function. (see picture 4).
7. CHECKING CORRECT OPERATION, BEFORE USE
CHECK THAT: 1.
The plug is connected.
3. The thermometer shows the desired temperature for the goods to be stored.
5
on. . The door is properly closed.
7
lamps. . The room temperature does not exceed that in which the appliance is designed to work
normally, i.e. +30°C, 55% r.h. (climatic class 4).
the motor grille to allow for correct ventilation.
shelves and with sufficient space for cold air circulation.
8. INTERNAL CLEANING (EVERY 15 DAYS)
1
. Switch off the appliance. . Open the door and remove the refrigerated goods. . Wipe the internal
surfaces of the appliance with a sponge dipped in water with a little sodium bicarbonate. Dry with care.
9. REPLACING THE DOOR'S MAGNETIC GASKET
1. Open the door. 2. Take hold of the magnetic gasket and pull it out of the frame. . Insert the new
gasket and press it firmly down all around (see figure 5).
Operator's guide
5
.
4. Display:
2.
The refrigeration unit switch is switched on (green light on).
6.
The appliance is not exposed to direct sunlight or to high-powered
8. There is suitable clearance (at least 30 cm) in front of
9.
The cabinet is suitably filled, without overloading the
2
7
4
to run the refrigeration
Thermostat:
5 "UP"
6 "DOWN" the temperature decreases.
2. Refrigeration :
to display the temperature in the appliance.
a) 5 "SET or P"
Press button
6 "UP"
or button
4. The internal lights are
3
3
to adjust the
the
to switch on the
once to display the
7 "DOWN" 9. Energy
.
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO