El-Skyport Transmitter Speed Rx Features; Integrated Sync Socket; Elinchrom Rx Features - Elinchrom BRX 250 Manual De Funcionamiento

English
SET Config Mode: (to configure included features)
- Switch module OFF.
- Hold test push button and switch TX ON.
- Keep test push button pressed until STATUS LED is ON.
 Check also EL-Skyport PC / MAC software 3.0 for changing Transmitter Speed setting.
The EL-Skyport Transmitter triggers the EL-Skyport Receiver modules in the following modes:
1. Off  Unit is OFF, no function.
2. Select Group - Group (1 to 4).
 Set switch to Group. and select Group 1 to 4.
 All corresponding EL-Skyport Receivers with the same selected Group (1 to 4) are triggered.
3. ALL Mode switch is set to ALL.
 All corresponding EL-Skyport Receivers are triggered regardless of which Group is selected.
Integrated Hot-Shoe SYNC 2.5 mm Socket
Use the included Sync cable to connect the integrated 2.5 mm Mono Jack socket with the camera or
lens PC socket directly.

EL-Skyport Transmitter SPEED RX Features

Compatible with Ranger RX, Style RX, Digital RX, BXRi 250 / 500, Ranger Quadra AS!
If the EL-Skyport Transmitter SPEED is used with the EL-Skyport Transceiver RX
, BXRi 250 / 500
the following EXTRA
or the Ranger Quadra AS,
features are available:
Depending upon which Group is selected, the following RX-unit settings can be modified:
1. Flash power increase in 1/10 f-stops.
 press push button + to increase the power of selected Group of (or ALL) RX-units in 1/10 f-
stops.
2. Flash power decrease in 1/10 f-stops.
 press push button - to reduce the power of selected Group of (or ALL) RX-units in 1/10 f-stops.
3. Modelling lamp toggle.
 press and hold the push button +, 2 seconds or longer before releasing,
to toggle modelling lamp of the selected Group of (or ALL) RX-units.
Power save mode timer:
- After not using the Transmitter for 30 minutes the Power Save mode is active. To reactivate the
Transmitter, press the TEST push button.
- The Power Save mode timer can be configured with the EL-Skyport PC / MAC software v 3.0 and
higher.
Status LED:
- LED flashes every 4 seconds one time in "Standard" mode and two times in "Speed" mode.
- LED intensity correspond to the battery status - if off or very low => exchange the battery.
- LED is OFF if the Transmitter is switched OFF or in Power Save mode.
.
Reset to manufacturer default setting:
- Switch ON.
- Press test button for min 10 seconds.
20