Exo Terra PT2457 Manual De Instrucciones página 8

SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
Only close adherence of these
installation, electrical and maintenance
guidelines will ensure the safe and
efficient use of this appliance.
EXO TERRA
®
INSTALLATION in Exo Terra
Follow this installation procedure to install the Exo Terra
Thermostat on any size of Exo Terra
1. Unlock the top screen cover and lift it off the terrarium.
2. Slide one of the inlet holes (located on the back of the screen
top on either side) to the open position, so the wiring will
fit through.
3. Feed the wire with sensor through the first available inlet hole
on the preferred side on the back of the screen cover.
4. Position the sensor inside your terrarium, in the location where
you want to reach the temperature set on the dial. This can
be on top of the substrate if you are using a Heat Mat or Heat
Cable, but this can also be on a branch, cave or pile of stones if
you are using a Ceramic Heater to heat up a certain
8
basking area.
5. Place the top screen cover back on the terrarium and lock it
into position.
6. Close the remaining inlets by sliding the slider against the
tubing or wires to prevent escape from feeding insects and
smaller animals.
7. Place the Exo Terra
8. Connect your heating device (Heat Mat, Heat Cable, Ceramic
Heater, etc.) to the receptacle of the thermostat. Controls
heating devices up to 300W.
INSTALLATION in other Terrarium Models
1. Refer to your terrarium's instruction manual for instructions on
how to install equipment, wiring and sensor cables inside
the terrarium.
2. Position the sensor inside your terrarium, in the location where
you want to reach the temperature set on the dial. This can be
on top of the substrate if you are using a Heat Mat or Heat Cable,
but this can also be on a branch, cave or pile of stones if you are
using a Ceramic Heater to heat up a certain basking area.
3. Place the Exo Terra
4. Connect your heating device (Heat Mat, Heat Cable, Ceramic
Heater, etc.) to the receptacle of the thermostat. Controls heating
devices up to 300W.
WARNING: Do not overload the Exo Terra
necting heat devices with outputs greater than 300W. Damage
from overloading is considered misuse and is exempt from the
guarantee.
THERMOSTAT 300W INSTALLATION INSTRUCTIONS
Natural Terrariums
®
Thermostat on a solid, level surface.
®
Thermostat on a solid, level surface.
®
®
Natural Terrarium:
®
Thermostat by con-
®