Eschenbach mobilux LED 15122 Manual De Instrucciones página 11

Using the mobiluxLED
You can use mobiluxLED with your reading glasses.
1. Hold the mobiluxLED with the lens centrally over the text that is to be magnified.
2. The optimal imaging quality with mobiluxLED is to be obtained when you maintain the distance to
the lens determined for you for the magnification used by you. This value (in mm) is to be found in the
chapter 'Technische Daten / Technical Data / Caratéristiques techniques' on page 3,
ing lens-eye) as well as above the switch on your mobiluxLED.
3. Switch the LED light on by sliding the shifter (e) in the direction of the lens (r). If you require
stronger illumination, fit the transparent LED filter cap (q) of the 3 enclosed LED filter caps, as
shown in the left figure on page 3.
4. After use, switch the LED light off by sliding the shifter (e) in the direction away from the lens (r).
Note: If the LED flickers, the batteries are drained and must be exchanged for new ones. In this case,
proceed as detailed in the chapter 'Initial device operation' .
If the colour of the light is unpleasant for you, you can place one of the enclosed LED filter caps (q,
orange or yellow) over the LED, as shown in the left figure on page 3.
To protect the lens your mobiluxLED is supplied with a case.
To enable you to hang your mobiluxLED around your neck it has an eyelet located on the end of the
handle and through which a lanyard, which is optionally available, can be threaded. (Stock.-No.
15981).
11
(Spac-