GYS GYSARC 160 Manual página 13

- The Hot Start creates an overcurrent at the beginning of the welding.
- The Arc Force creates an overcurrent which prevents the electrode from sticking to the weld pool.
- The Anti-Sticking technology makes it easier to unstick the electrode from the metal.
TROUBLESHOOTING
Troubleshooting
The 2 indicators are on, but the ma-
chine does not deliver any current.
The green indicator is on, but the
machine does not weld.
The product is under voltage, you are
feeling tingling when touching the
machine's body.
The machine welds poorly.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
GYSARC 80 / 100 / 120 / 160 / 200
Causes
The thermal protection has switched
on.
Current too high on the primary
circuit.
Fault with earth clamp/cable connec-
tion.
The earth contact is faulty.
Polarity error (+/-).
Solutions
Wait for the end of the cooling cycle.
Switch off the unit (with the on/off
switch), then turn it on.
Check the connections
Check the plug and the earth of your
installation.
Check the polarity (+/-) recom-
mended on the electrode box.
EN
13 13