Descargar Imprimir esta página

Voltr GTJ250WAC Manual Del Usuario página 37

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
TO START/TURN OFF
Connect the device to the extension, then the electrical extension to the sector.
Press the trigger (3) to start.
Release the trigger to cut the engine.
MOWING
The cutter cutting is able to effectively cut the lawn up to a height of 15 cm. When the lawn is higher,
perform several successive cuts..
1
Cut the grass by moving the-spot cut from right to left and slowly carry out the tilted border cut of
about 15 °.
It is not recommended for cutting wet or wet grass. The dry grass cut gives better results.
REPLACEMENT OF THE WIRE COIL
Disconnect the device from the power outlet.
Turn the device back with the housing in front of you.
Remove the coil cache, simultaneously pressing the two
side clips.
Remove the old coil of wire, taking care not to Lose the
spring located under the coil. Clean the inside coil sup-
port, carefully removing all the grass residues and dust.
Remove the coil cover and remove the wire.
Replace the spring and place the new coil. Now insert the
new wire with the coil (nylon wire Ø1.2mm), then you can
put the cover from the Spool and insert each side of the
wire into the side holes provided for this.
Put the cache back on the head and make sure it is
lock well.
Set the length of the nylon thread again by pushing
the head of the coil support and pull the wire to the length
desired (about 10 cm).
30/03/2023
2
3
EN
37

Publicidad

loading