Publicidad
Idiomas disponibles
Idiomas disponibles
EN
MAINTENANCE
WARNING : Before all work on the device, disconnect the device in the sector.
•
Regular cleaning and maintenance of your-edge cutting will preserve its effectiveness and extend
the life of your device.
•
After each cutting operation, disassemble and eliminate the grass and the earth from the following
elements: the coil and its slit, the entire-edge cutter and in particular the protective housing.
•
During operation, keep the ventilation slots free and free from herbs.
•
Use only a cloth soaked in hot water and a soft brush to clean the storekeeper.
•
Do not spray water on the device and do not wet it.
•
Do not use detergents or solvents, which can destroy the earning cut. Plastic parts can easily be
damaged by chemicals.
•
If the wire does not cut any more, that the coil is broken, or any other problem not mentioned in this
manual, contact your Voltr/Alice's Garden after -sales service.
•
After use, disconnect the device from the power supply and control it for possible damage.
•
When it is not used, store the device out of the reach of children.
•
Inspect and regularly maintain the earning cutter. The repairs on this-storey cutter must be super-
vised by the Voltr / Alice's Garden after-sales service, and the parts recommended by the latter.
•
The user can make maintenance and certain settings. Please consult the 'REPLACEMENT OF
THE COIL'..
RECYCLE THE EDGE CUTTING
The components of the borders cut can contain dangerous elements for the environment and should
not be thrown into the wild or with your household waste. In order to avoid any risk for the planet, here
is the procedure to throw your tool:
•
Cover the terminals of the socket with adhesive tape.
•
Do not try to dismantle or access the components of the device.
•
Do not incinerate the machine.
•
Throw the elements in a recycling center or an approved recycling center.é.
38
30/03/2023
Publicidad
