SOMFY Ramp RTS-HR1 Manual De Instrucciones página 37

Installation guide
3.5.1 Installing accessories on a wall/ceiling/awning casing
1) Drill two holes 6 mm in diameter, spaced approximately 30 cm apart, to
affix the Heating Mod/Var Ramp RTS-HR1 (a).
2) Insert the plugs (f) in the holes, using a hammer if necessary.
3) Press the support brackets (b) against the wall over the holes and fix
in place using the screws (g).
- If installing accessories onto the awning casing, fix the support
brackets on directly (b) using an M5 nut and bolt (not supplied).
Caution! The nut and bolt must not come into contact with the awning fabric. Risk of tearing.
3.5.2 Installing accessories on the Heating Mod/Var Ramp
RTS-HR1
1) Remove the cover from the Heating Mod/Var Ramp RTS-HR1 on
the side with the "Somfy" logo (a) using a 2 mm Allen key (not
supplied).
2) Slide the "T" supports (d) along the chosen groove on the back of the
Heating Mod/Var Ramp RTS-HR1 (a).
3) Close the cover of the Heating Mod/Var Ramp RTS-HR1 again using
a 2 mm Allen key (not supplied).
4) Screw the pivoting joints (c) into the threads of the "T" supports (d).
Caution! Do not fully tighten the pivoting joints (c) onto the "T"
supports (b) in order to allow them to slide along the groove.
3.5.3 Mounting the Heating Mod/Var Ramp RTS-HR1
1) Slide the assembly comprising the "T" supports (d) and the pivoting
joints (c) along the groove until they line up with the support brackets
(b) previously fitted
2) Fully tighten the pivoting joints (c) onto the "T" supports (d) on the
Heating Mod/Var Ramp RTS-HR1 (a)
Caution! Ensure that the Heating Mod/Var Ramp RTS-HR1 can still be
inclined once installed.
3) Lock the pivoting joints in place (c) using the flat spanner (k) (not
supplied) and tighten the screws (h) using the Allen key (e).
4) Insert the upper section of the pivoting joints (c) into the support
brackets (b) and use an Allen key (e) to fix the pivoting joints (c) to
the support brackets (b) with the screws (h).
3.5.4 Mounting the Heating Mod/Var Ramp RTS-HR1 with an awning
- When fitting the equipment to an awning, the mounting systems
[support brackets (b), pivoting joints (c) and "T" supports (d)] must be
replaced by direct mounting systems (m). These systems supplied
by Somfy are fixed directly onto the awning's square bar (up to
40 mm). Please contact the dealer for further information.
Copyright © 2008-2010 Somfy SAS. All rights reserved.
Heating Mod/Var Ramp RTS-HR1
f
b
g
1
2
d
3
4 c
d
1 b
b
d
c
2
d
k
3
h
e
h
4
e
b
e c
c
h
m
c
d
c
c
b
35