Indel B TB 31 OFF Instrucciones De Uso página 22

USING THE REFRIGERATOR
IN A VEHICLE
- Connect the feeding cable to a direct current 12 or 24 V DC power source.
- Make sure the polarity is right.
- The supply line is protected by a 15 A fuse located on the box.
- If connected to an existing cigarette plug, carefully check up that power supply is sufficient.
- If the supplied power cable is not used, see the table containing the information related to the cable section:
CABLE AREA
MM2 (AWG)
2,5 (AWG 13)
4 (AWG 11)
6 (AWG 9)
ELECTRONIC CONTROL
COMPRESSOR STATION - FUNCTIONS AND FEATURES
This is an electronic device which has the function of piloting the motor of the compressor and carrying out all the controls
and electrical protection of the system.
Its main features are as follows:
a) Protection of the battery through automatic turning off of the compressor when the feeding voltage reaches the minimum
threshold.
The compressor will start up again automatically when the voltage goes back to normal values.
Note: these values have been measured at control unit input and/or on the DC socket.
BATTERY PROTECTION
(SWITCH POSITION)
LOW
MED
HIGH
20
MAX CABLE LENGHT METRES (FT)
12V
2,5 (8 FT)
4 (13 FT)
6 (20 FT)
CUT-OUT
12V
9.6
10.1
11.1
TB 31-41-51 OFF_20230111
24V
5 (16FT)
8 (26 FT)
12 (40 FT)
CUT-IN CUT-OUT
12V 24V
10.9 21.3
11.4 22.3
12.4 24.3
CUT-IN
24V
22.7
23.7
25.7