Publicidad
Idiomas disponibles
Idiomas disponibles
USE OF THE CONTROL PANEL
- Plug in the DC power. Press the button `ON/OFF` to run
the refrigerator. The LED display on the control panel would
be lighted and the interior temperature would be displayed.
- Press the button
and
Press the button
to increase while the button
decrease the temperature. When press the above two
buttons at the same time, it would switch the display
between °C and °F.
- Press the ECO key to enter the "ECONOMY" operating
mode: the ECO light turns on and the compressor runs at
minimum speed by keeping a fresh temperature inside
the refrigerator. By pressing the ECO key again, the light
turns off and the refrigerator enters in MAX mode (mode
(maximum number of compressor turns). MAX light will be
switched on until having achieved the temperature set.
OFF-SET VALUE
This is the information needed to align the temperature shown on the display with the actual temperature inside the
refrigerated compartment. Each off-set can be adjusted within a range of from -10 to +10.
After running the refrigeration system for a few hours, place a digital thermometer (not supplied) inside the compartment, in
a location where a more accurate temperature is required, and check that the temperature shown on the display coincides
with the temperature shown on the digital thermometer. If the temperature is not the same, the off-sets must be adjusted
in relation to the temperature T you want the inside of the compartment to reach, so that the temperature reading on the
display coincides with the temperature indicated by the thermometer. The following table shows the factory off-set setting
for each temperature range and the adjustment range for changing these settings.
OFF-SET
F1
F2
F3
With the refrigerator switched on, press and hold the ECO/MAX +
access the OFF-SET value adjustment.
Press the
and
buttons number of times to scroll through the three functions (F1-F2-F3) in succession. Once you have
selected the function you wish to change, press the ECO/MAX button to access the selected OFF-SET value and press the
and
buttons to change the factory setting, while remaining within the +10°C ÷ -10°C range. Without having to press any
other button to confirm, the display will automatically save the setting and exit programming mode.
22
to adjust the temperature.
TEMPERATURE RANGE
T ≥ -6°C
-12°C ≤ T ≤ -6°C
T ≤ -13°C
TB 31-41-51 OFF_20230111
to
TEMPERATURE
FACTORY SETTING
-3°C
-5°C
-7°C
+
buttons at the same time for a few seconds to
ECO
ON/OFF
MAX
ADJUSTMENT
RANGE
+10°C ÷ -10°C
+10°C ÷ -10°C
+10°C ÷ -10°C
Publicidad
