Publicidad
Idiomas disponibles
Idiomas disponibles
Playing back music files stored on the
computer
1
Connect the unit to the computer using a USB
cable.
o To use a Windows computer, you must install the
dedicated driver beforehand (see page 12).
o Use a cable with a connector that fits the USB port
on the unit.
2
Turn the computer on.
o Confirm that the computer has started up correctly.
3
Press the ¤ button to turn the unit on.
4
Press the source button repeatedly to select
"USB".
5
Start playback of the music file on the computer.
If you can adjust the volume from the computer, set it to
its maximum level and use this unit's VOLUME knob to
adjust the level for the best audio quality.
o If you are using the TEAC HR Audio Player Application,
the volume cannot be adjusted from the computer.
Turn this unit's VOLUME knob to MIN before starting play-
back. Then, gradually turn it up.
o The computer and this unit cannot control each other.
o When playing back a music file using the USB connection, do not attempt any of the following operations.
Doing so could cause the computer to behave irregularly. Always stop music playback software on your
computer before doing any of the following.
o Disconnect the USB cable
o When playing back a music file using the USB connection, computer operation sounds will also be played
through this unit. To avoid this, make appropriate settings on the computer.
o If you connect this unit with the computer or you set this unit's input to "USB" after starting music playback
software, music files might not play back properly. If this occurs, restart the music playback software or
restart the computer.
o Put the unit into standby
USB cable
o Change the input source
13
Publicidad
