Descargar Imprimir esta página

Teac UD-301-X Manual Del Usuario página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

Analog audio output
Jacks . . . . . . . . . . . . . . . . . . . . . . XLR jacks (2 channels) × 1
Output impedance . . . . . . . . . . . . . . . . . . . . . . . XLR: 200 Ω
Maximum output level (1 kHz, full scale, 10 kΩ)
Frequency response . . . . . . . . . . 5 Hz to 55 kHz (−3 dB)*
Signal-to-noise ratio (S/N) . . . . . . . . . . . . . . . . . . . . . 105 dB
Total harmonic distortion . . . . . . . . . . . 0.0015% (1 kHz)*
*At 192kHz sampling frequency
Headphones output
Connector type . . . . standard 6.3mm (1/4") stereo jack
Maximum output . . . . . . . . . . . . . . . . .100 mW + 100 mW
(into 32Ω load with 0.1% distortion)
Nominal load impedance . . . . . . . . . . . . . . 16 Ω to 600 Ω
16
Specifications
RCA jacks (2 channels) × 1
RCA: 100 Ω
XLR (Gain: 0 dB): +14 dBu
RCA: 2.0 Vrms
Digital audio input
RCA jack × 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 Vp-p
Optical digital connector × 1
USB port (type B) connector . . . . . . . . . . . . . . . . . .USB 2.0
Supported sampling frequencies (PCM) in kHz
32
1)
/44.1/48/88.2/96/176.4/192
Data bit length . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16/24/32
Supported sampling frequencies (DSD)
2.8/5.6 MHz (only when connected by USB)
1) If the sampling frequency of the input signal is 32 kHz, no
frequency indicator lights, but the input indicator does.
2) The maximum is 96 kHz when using the optical digital
input.
3) Only during USB input
(input impedance 75 Ω)
−24.0 to −14.5 dBm peak
2)
3)

Publicidad

loading

Este manual también es adecuado para:

Ud-301