Motor Management; Adjusting The Carburetor; General Information - Stihl MS 360 C Manual De Instrucciones

english / USA
6
5
:
Remove the foam filter element (5)
from the front half (6) and clean or
replace as necessary.
:
Knock the two halves of filter out on
the palm of your hand or blow them
clear with compressed air from the
inside outwards.
In case of stubborn dirt:
: Wash the filter components in
STIHL universal cleaner or a clean,
non-flammable solution (e.g. warm
soapy water) and then dry.
Do not use a brush to clean the fleece
filter.
: Always replace a damaged filter
element.
: Reinstall the air filter.
44

Motor Management

Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.

Adjusting the Carburetor

General Information

The carburetor comes from the factory
with a standard setting.
This setting provides an optimum fuel-air
mixture under most operating
conditions.
With this carburetor it is only possible to
adjust the engine idle speed within fine
limits.
MS 360 C