Speaker Setting; Clock Display; Adjusting Clock; Dimmer Control - Kenwood KDC-1028 Manual De Instrucciones

General features

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "STBY" display.
2
Enter Speaker Setting mode
Press the [VOL] knob.
3
Select the Speaker type
Turn the [VOL] knob.
Each time the knob is turned, the setting
switches as shown below.
Speaker type Display
OFF "SP-F"
For 5 & 4 in. speaker "SP-5"
For 6 & 6x9 in. speaker "SP-6"
For the OEM speaker "SP-O"
4
Exit Speaker Setting mode
Press the [VOL] knob.

Clock Display

Press the [CLK] button.
Each time the button is pressed, the clock display
turns ON and OFF.
10
|
English

Adjusting Clock

1
Enter Standby
Press the [SRC] button.
Select the "STBY" display.
2
Select the clock display
Press the [CLK] button.
3
Enter clock adjustment mode
Press the [CLK] button for at least 2 seconds.
The clock display blinks.
4
Adjust the hours
Push the Control knob to [FM] or [AM].
Adjust the minutes
Push the Control knob to [4] or [¢].
5
Exit clock adjustment mode
Press the [CLK] button.

Dimmer Control

You can change the unit's display to dimmer.
Press the [ATT] button for at least 1 second.
Each time the button is pressed for 1 second, the
Dimmer contol turns ON and OFF.
When it's ON, "on DI" is displayed.

DSI (Disabled System Indicator)

A red indicator will blink on the unit after the
faceplate is removed, warning potential thieves.
1
Turn the power OFF
Press the [SRC] button for at least 1 second.
2
Set the DSI
While pressing the [1] and [3] button, press
the [SRC] button.
Release your fingers from the button after the
display is appeared.
Each time the step 1 and 2 operations are done,
the DSI turns ON and OFF.