Ryobi PBLMS01 Manual Del Operador página 31

NESTING CROWN MOLDING AGAINST THE
MITER FENCE
See Figure 40 - 41.
NOTE: This method of cut is for crown molding between
4-5/8 in. and 5-1/4 in. tall. Do not attempt to cut molding
that is larger than 5-1/4 in. tall.
NOTE: It may be necessary to adjust the partial sliding fence
to ensure proper clearance prior to making the cut.
 Set the bevel angle at 0° and the miter angle at 45° to
either the left or the right. (For making 90° corners.)
 Nest and secure the crown molding against miter fence
using a spring clamp and hold crown molding securely.
 Before turning on the saw, perform a dry run of the cut-
ting operation to make sure that no problems will occur
when the cut is made.
 Grasp the saw handle firmly. Depress the trigger lockout
lever and squeeze the switch trigger. Allow several sec-
onds for the blade to reach maximum speed.
 Slowly lower the blade into and through the crown molding.
 Release the switch trigger and allow the saw blade to stop
rotating before raising the blade out of the workpiece and
removing the workpiece from the miter table.
OPERATION
SPRING
CLAMP
31 − English
SPRING
CLAMP
BOTTOM EDGE
AGAINST FENCE
Fig. 40
CROWN
MOLDING
Fig. 41