INDUSTRIAS TECHNOFLEX Super II Manual De Instrucciones página 16

1B
OPERATION
Read All Instructions
Familiarity and proper training are required for the safe operation of this equipment! Equipment
operated or serviced improperly or by untrained personnel can be dangerous! Read all operating
instructions and the safety notes below. Familiarize yourself with the proper use of this equipment
before operating it.
1.Keep your work area clean and free of clutter.
2.Keep your work area well lit.
3.NEVER operate motor in areas exposed to
flammable or explosive liquids or gases!
4.DO NOT allow children or people other than
the operator to handle power cables, extension
cords or the equipment.
5.DO NOT allow non-essential personnel or
visitors in the work area.
6.NEVER carry motor by cord or pull on it to
disconnect it from receptacle. Keep cord away
from heat, oil and sharp edges.
7.Stay alert! Watch what you are doing. Use
common sense. NEVER operate the vibrator
motor when you are tired or while under the
influence of drugs, alcohol, or medication.
8.Keep hands, feet, hair and loose clothing away
from moving parts. They can be caught in
moving parts.
9.Avoid unintentional starting! DO NOT carry
motor around jobsite while it is connected to
power source. DO NOT carry motor with finger
on switch.
10.DO NOT operate equipment if switch does
not operate properly.
1B-3
WARNING
11.DO NOT overreach! Keep proper footing
and balance at all times. Make sure any
supporting structures are strong enough
and stable enough to support your weight
and the weight of any equipment on it.
12.Wear protective clothing when operating
equipment. Goggles or safety glasses will
protect against eye damage caused by
flying debris.
13.DO NOT force tool. Use the correct tool for
which it is designed.
14.NEVER allow untrained personnel to
operate or service the equipment.
15.Maintain tools with care. Keep vibrator unit
clean for better and safer performance.
Inspect motor cord periodically and if
damaged, have it repaired by an authorized
service facility.
16.NEVER use the motor with a defective
switch. If the switch does not turn the motor
"ON" or "OFF", have it repaired by an
authorized service facility before using the
motor.
17.Replace worn or damaged parts with
replacement
recomended for use by INDUSTRIAS
TECHNOFLEX S.A.
18.Any servicing, other than that covered in
this
performed by an authorized INDUSTRIAS
TECHNOFLEX S.A Service Representative.
Save these instructions!
parts designed
instruction manual,
and
should be
INGLÉS
16