Assembly Instructions; Use Of Extension Cords - INDUSTRIAS TECHNOFLEX Super II Manual De Instrucciones

1.7

Assembly Instructions

Transmission Assembly: To assemble the flexible transmission to the motor, press the locking
button down completely, then the transmission coupling is introduced into the coupling of the engine,
making the two planes of the terminal cable coincide with the coupling lug, and introduce softly until
the locking button coincides with the safety housing of the engine. If it drags DO NOT FORCE, make
the engine turn slightly to ease the introduction and perfect coupling. (See Fig.: 1.7-1)
Starting of the electric motor:
Before starting the electric motor, it will be checked that the network voltage coincides with the that
indicated on the characteristics plate, it will also be verified if the current collection is the same as that
of the motor.
Starting of the petrol engines for the first use:
A) For measuring of security in the transport of shipment, all the machines are given without
oil and without fuel in the motors.
B) Fuel: Filling the tank of fuel, all the petrol engine of the CLASSIC Vibrator, it use gasoline for
automobile that is clean, of 95 unleaded octanes.
C) Oil: Filling the tank of oil of the motor, following the instructions of respective lubrication of the
maker of the motor that are attached to this manual.
With temperatures below 3° C., the vibrator may pres ent difficulties to start after a long period
stopped, this is due to the solidifying of the grease bearings and of the shaft, it must start letting the
vibrator run light long enough for normal vibration to be achieved.
1.8

Use of Extension Cords

The extension cords are often required on jobsites to connect the motor. When choosing an
extension cord make sure it has adequate wire size for safety. An undersized cord will cause a drop
in line voltage resulting in a loss of power and overheating. In the Table 1.8-1 It shows the correct
wire size to use depending on cord length. If in doubt, use the next havier cord size.
On motors being used outdoors, use extension cords rated for outdoor use.
INGLÉS
OPERATION
Fig.: 1.7-1
1B
1B-6
19