Maintenance Instructions - INDUSTRIAS TECHNOFLEX Super II Manual De Instrucciones

1.10

Maintenance Instructions

ALWAYS MAKE CERTAIN that the switch is in the "OFF" position
and the power cord is disconnected from the power source.
That must be carried out every 100 hours of functioning or depending on the conditions of use and at
the maximum every six months, to a complete overhauling of the vibrator.
Needle: The overhauling will be carried out by dismantling all the components, checking the their
-
state and substituting the part which is deteriorated, clean and grease the bearings.
Flexible Shaft and Cover: In each overhauling, the shaft will be fattened cleaning first with a dry
-
cloth and spreading a fine covering of fat in the outside of the shaft with a brush.
The greasing of the bearings must be done with special high speed bearing grease,
-
Staburags NBU-4 or Isoflex NBU-15 from the firm KLÜBER LUBRICATION or any other
equivalent one.
When the needles are manipuled or dismantled the close joints must be changed and the screws
-
sealed with LOCKTITE 243. Wait for one hour before using.
Electric Motor: The state of the plug, electric cable, switch, bearings must be checked.
-
- Petrol Engine: See maintenance Instructions of the manufacturer of the engine, which
accompany this manual.
Before starting the engine check the oil level, if it is low refill it, if it is dirty substitute it.
The parts which are seen to have excessive wearing, the loose bearings, heat up or make too much
noise, must be substituted and always remember ORIGINAL SPARE PARTS MUST BE USED.
Once the vibrated has ended, it is convenient to disconnect the transmission of the motor.
For safety reasons and so as to avoid accidental starting, DO NOT forget to disconnect the
electric motor from the network, when some kind of operation or part substitution is made.
INGLÉS
WARNING
Before performing any maintenance on this unit,
OPERATION
1B
1B-8
21