Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning the Glass Cooktop (Cont.)
Metal Marks and Scratches
1. Be careful not to slide pots and pans across your
cooktop. It will leave metal markings on the cooktop
surface.
These marks are removable using the CERAMA
BRYTE
Ceramic Cooktop Cleaner with the CERAMA
®
BRYTE
Cleaning Pad for Ceramic Cooktops.
®
Cooktop Seal
To clean the cooktop seal around the edges of the glass,
lay a wet cloth on it for a few minutes, then wipe clean
with nonabrasive cleaners.
Damage from Sugary Spills and Melted Plastic
Special care should be taken when removing hot substances to avoid permanent damage of the glass surface.
removing hot substances.
Be sure to use a new, sharp razor scraper.
1. Turn off all surface units. Remove hot pans.
2. Wearing an oven mitt:
BRYTE
®
spill to a cool area on the cooktop.
b. Remove the spill with paper towels.
49-88057-2
2. If pots with a thin overlay of aluminum or copper
are allowed to boil dry, the overlay may leave black
discoloration on the cooktop.
This should be removed immediately before heating
again or the discoloration may be permanent.
NOTE: Carefully check the bottom of pans for roughness
that would scratch the cooktop.
3. Any remaining spillover should be left until the surface
of the cooktop has cooled.
residue has been completely removed.
NOTE: If pitting or indentation in the glass surface has
already occurred, the cooktop glass will have to be
replaced. In this case, service will be necessary.
21
Publicidad
