Publicidad
Idiomas disponibles
Idiomas disponibles
Oven Door
If improperly removed, oven door hinges may suddenly open and can cause personal injury to
WARNING
appendages near the hinge. Follow instructions below to avoid a risk of injury when removing and
re-installing the oven door.
To Remove the Door:
1. Fully open the oven door.
2. On each hinge, slide the hinge lock up, making sure it
snaps into its fully raised position.
3. Firmly grasp both sides of the door at near the top.
4. Close door until the top of the door is approximately
3" from the range frame.
5. Lift door up and away from the range until both hinge
arms are clear of the slots in the range frame.
To Replace the Door:
1. Firmly grasp both sides of the door near the top.
2. With the door at the same angle as the removal
position, rest the notch in the bottom of the left hinge
arm on the bottom edge of the left hinge slot. The
notch in the hinge arm must be fully seated onto the
bottom of the slot. Repeat for the right side.
3. Fully open the door. If the door will not fully open,
the notches in the bottoms of the hinge arms are not
seated correctly onto the bottom edge of the slot. Lift
the door off the range and repeat Step 2.
4. Push the hinge locks down to the locked position
5. Close the oven door.
Storage Drawer (on some models)
To remove the drawer:
1. Pull the drawer out until it stops.
2. Lift the front of the drawer until the stops clear the
guides.
3. Remove the drawer.
To replace the drawer:
1. Place the drawer rails on the guides.
2. Push the drawer back until it stops.
3. Lift the front of the drawer and push back until the
stops clear the guides.
4. Lower the front of the drawer and push back until it
closes.
49-88057-2
Pull hinge locks up to unlock
Notch
Rail
Removal position
Push hinge locks down to lock
Stop guide
23
Publicidad
