Playcore Swing-N-Slide NE 4569L Instrucciones De Ensamblaje página 7

Fig. 8
Optional Seesaw nchoring Method:
1. Place the Seesaw in the desired position. Mark a 12'' x 12'' square around each of the Seesaw feet and, using these guidelines,
dig holes 14'' deep.
2. Fill each hole with a minimum of 12'' of concrete. Do not exceed the ground level.
3. Place Seesaw back in desired position so that ends of legs are centered over cement fill.
4. Fit the anchor into the center of the concrete so that their tops rise out of the concrete and loop over ends of legs.
Note: Remove anchors before concrete sets, creating a mounting hole in the cement.
5. Once concrete is dry, slide anchors into mounting holes. Fill in remaining area of holes with surfacing and compact until firm.
Note: Do not use the Seesaw until the concrete is completely dry and holes are filled.
H
11-3/4''
Weight Limit: 85 lbs Per Child
7
ssembly Instructions
x3
H
H
27-1/2''