HP OneShred 24CC Manual De Instrucciones página 16

EN
Oiling the Cutting Mechanism
If you want to increase the working life of the shredder, you should oil the shredder's cutting
mechanism at regular intervals.
Special oil and oiled sheets are available for the shredder from HP.
Important!
Risk of property damage through using the wrong oil! Do not use spray oils. Only use a special oil
intended for shredders.
There are various ways to oil the cutting mechanism.
Oiling Using Self-Oiled Paper:
1 Apply the special oil for shredders in several lines horizontally across a sheet of paper.
2 Insert the oiled sheet of paper in the insertion slot.
Î The paper with oil applied is inserted and oils the cutting mechanism.
Oiling Using Oiled Sheets
1 Insert the oiled sheet in the paper infeed.
Î The paper with oil applied is inserted and oils the cutting mechanism.
Emptying the Waste Bin
The fill level of the waste bin is monitored by a sensor.
When the fill level is high, the "Bin full" status LED flashes RED. The cutting mechanism of the
shredder stops and you must empty the waste bin.
1 Switch the device off by pressing the On/Off button.
2 Pull the waste bin out of the device.
If you have not switched the device off, the "Bin open" status LED lights up RED.
3 Empty the waste bin.
4 Slide the waste bin in the device.
Î The waste bin latches audibly in place.
Î You have emptied the waste bin.
- 16 -