Publicidad
Idiomas disponibles
Idiomas disponibles
Metal Bowl
Never use a wire brush, steel wool or bleach to clean your stainless steel
bowl. Use vinegar to remove limescale. Keep away from heat (cooker tops,
ovens, microwaves).
Before plugging in
Make sure your electricity supply is the same as the one shown on the underside of the
power unit.
Important – Plug and Fuse Information
The wires in the cord are coloured as follows:
Blue = Neutral, Brown = Live.
If the plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock
hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into
a socket outlet.
If the plug supplied with your appliance has a fuse fitted and the fuse fails it must be
replaced with one of the same rating.
Note:
For non-rewireable Plug Type G the fuse cover MUST be refitted when replacing the
fuse. If the fuse cover is lost then the plug must not be used until a replacement can
be obtained. The correct fuse cover is identified by colour and a replacement may be
obtained from your Kenwood Authorised Repairer (see Service).
Plug Type G
This appliance conforms to EC Regulation 1935/2004 on materials and articles intended
to come into contact with food.
Key
Speed & Pulse selector
1
Tool SureEject™
2
Mixer
3
Beater
4
Beater with gear
5
Kneader
6
Kneader with gear
7
Mixing bowl
8
Cradle
9
Mixer release button
10
Cradle release lever
11
Stand
12
Splashguard
13
To Use your Handmixer
Fitting the Beaters/Kneaders
Refer to illustration
Insert the beater/kneader with the plastic
gear in the
socket.
Setting Up the Bowl & Stand
Refer to illustration
1
Fit the beaters/kneaders to the
Handmixer.
2
Hold the front of the cradle and raise
by pressing the cradle release lever.
3
Place the bowl onto the stand.
4
Fit the mixer to the cradle and push
down to secure.
Note: Check that the beater/kneader
with the plastic gear aligns with the
drive gear on the cradle.
3
A
C
–
D
H
–
Publicidad
