Kenwood Chefette HMP54.000SI Instrucciones página 8

5 Add the ingredients, then lower the
cradle by holding the Handmixer
handle whilst pressing the cradle
release lever at the same time.
6 Plug in and select a speed (Refer to
the recommend usage chart).
Pulse
Slide the speed selector to the (P)
position to use in short bursts at
maximum speed. Note: the motor will
only operate for as long as the control
is held in position.
Splashguard
Fit the splashguard if required
After Use
Refer to illustration
1 Switch the speed selector to the 'O'
OFF position.
2 Hold by the handle and lift up the
cradle by pressing the cradle release
lever.
3 Remove the mixer from the cradle by
pressing the mixer release button and
lifting off.
4 Slide the tool SureEject™ down to
release the tools.
Note: The tools can only be removed
when the speed selector is in the 'O'
OFF position.
Note: When ejecting the tools hold the
hand mixer over the bowl.
Cord Storage
Wrap the cord round the heel of the
handmixer. Then store on the stand.
G
.
K
I
–
L
Hints and Tips
Start at low speed and as the mixture
thickens, increase the speed.
If the machine starts to slow or labour,
increase the speed.
Scrape down the sides and bottom of
the bowl at regular intervals to assist
the mixing operation.
When creaming for cake mixtures,
use butter or margarine at room
temperature or soften before use.
For best results with small quantities,
use the handmixer without the stand.
Large quantities and thick mixtures
may require a longer mixing time.
If you wish to mix larger quantities
or heavier mixes, remove the mixer
from the stand and use a bowl of an
appropriate size.
When re-kneading dough after
proving it is recommended that the
mixer is removed from the cradle and
used hand held.
4