Gude GKH 2000 Traducción Del Manual Original página 22

ENGLISH
The unit now regulates the room temperature auto-
matically via the room thermostat by automatically
switching off when the set temperature is exceeded
and switching on again when the temperature falls
below this temperature. For this purpose, heating
level 1, 2 or 3 must be set by toggle switches
.
2
Note
The desired room temperature should be higher than
the current room temperature.
Switch off unit
1. Set the infinitely variable control
thermostat to min.
2. Switch off the appliance by turning off the two
toggle switches
1
must both go out).
3. Unplug the mains cable from the mains socket.
4. Let the appliance cool down completely.
22
and
1
3
of the room
and (the indicator lights
2
Troubleshooting
Problem Cause
Unit has no power
supply
Unit, mains cable
or mains plug is
defective
The room tempe-
rature is above the
temperature set
on the thermostat
Unit without
function/not
heating
The safety thermo-
stat has triggered
The overheating
protection has
triggered
Reduced Air inlet and outlet
airflow not free
Note
After all troubleshooting, maintenance and cleaning
work, wait at least 5 minutes before switching the unit
on again.
If the unit still does not work properly, please contact
the customer service or an authorised electrician. The
unit must then be checked and repaired if necessary.
Solution
Check the socket
Plug in the mains
plug correctly
Check the house
fuse
Contact customer
service or a
specialist
Increase the ther-
mostat tempe-
rature
Switch off the
unit and discon-
nect the mains
plug.
Eliminate the cau-
se of overheating
before restarting
the appliance.
Switch off the
unit and discon-
nect the mains
plug.
Contact customer
service or a
specialist
Clean and ob-
serve minimum
distances