Husqvarna DE 120 H PACE Manual Del Usuario página 16

Hour meter
The hour meter shows the total operation time of the
product in hours.
To remove dust particles from the
prefilter during operation
The filter purge procedure cleans the prefilter from
unwanted material. Do the procedure in these situations:
• Before a work stop or at the end of each work day.
If the product is off for a while, it gives the dust
more time to fall down. This makes the filter purge
procedure more powerful.
• When the suction is not sufficient.
• Before installation of a new Longopac bag.
• When the prefilter clogged alarm goes off.
1. Stop the product and let the dust fall down into the
Longopac bag.
2. Start the product. Refer to
15 .
3. Close the air flow that moves through the air intake
with the air intake plug or the intake valve to make
vacuum.
4. Wait 5 seconds until vacuum is made, then push the
filter purge button. Do this step 3 to 5 times. It is
important to let the product make vacuum between
each button push.
X 3-5
If the suction is not sufficient after this procedure, it is
necessary to clean the prefilter with water. Refer to
clean the prefilter with water on page 20 .
16
To start and stop on page
To
To install a new Longopac bag cassette
CAUTION:
you install a new Longopac cassette. Refer
To clean the prefilter with water on page
to
20 .
1. Put the Longopac cassette around the inner edge of
the Longopac holder.
2. Remove the 4 straps after you put the Longopac in
the holder.
3. Pull the inner layer of the Longopac cassette up (A)
and fold it into the holder (B).
A
4. Attach the Longopac holder to the rear part of the
container (A). Then attach the Longopac holder to
the sides and to the front of the container (B). Push
the Longopac holder up until you hear a solid click.
A
Clean the prefilter before
B
1618 - 006 - 01.06.2023
B