SGL Smarty Manual De Uso Y Mantenimiento página 27

The setting sequence is the following:
1st pressure
+3
Red LED on
To exit the temperature setting mode, press the on button ❽.
To enter the dose self-learning mode, switch the machine
on, wait until it reaches the heating temperature, and then:
• Press for 3 seconds (continuous pressure) the short cof-
fee dispensing buttons ➌ (the machine emits a "beep"):
• Release the button when the blue LED starts blinking.
• Press the coffee button you want to set (short ➌ or long
❹). The machine starts delivering (red flashing LED).
Upon reaching the desired dose in the cup, press the cor-
responding button again.
• The machine ends dispensing and the new dose is mem-
orized.
• It is possible to set the new dose immediately through the
same button or another available one.
• Press the on button ❽ to return to the normal operation
mode.
Note: To reset the default values, press and hold the coffee
dispensing buttons ➌ and ❹ for 3 seconds. The machine
emits a "beep". Release the buttons.
2nd pressure
Standard
Blue and red LEDs on
DOSE SELF-LEARNING
3rd pressure
Blue LED on
AUTOMATIC
Version
MANUAL
version
MANUAL
version
EN
-3
17
MANUAL
Version
18
19
27