Ariston FA5 844 JH IX A Guía Rápida página 4

Download the Use and Care Guide from
docs . hotpoint . eu for the table of tested recipes, compiled
CLEANING AND MAINTENANCE
Make sure that the oven has cooled
down before carrying out any
maintenance or cleaning.
Do not use steam cleaners.
REMOVING AND REFITTING THE DOOR
To remove the door, open it fully and lower the catches until
they are in the unlock position (1). Close the door as much as you
can (2). Take a firm hold of the door with both hands - do not
hold it by the handle. Simply remove the door (3) by continuing
to close it while pulling it upwards (a) at the same time until it is
released from its seating (b).
~60°
1 2
Put the door to one side, resting it on a soft surface. Refit the
door by moving it towards the oven, aligning the hooks of the
hinges with their seating and securing the upper part onto its
seating. Lower the door and then open it fully. Lower the catches
into their original position: make sure that you lower them down
completely. Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat the steps
above.
CLICK & CLEAN - CLEANING THE GLASS
After removing the door and resting it on a soft surface with the
handle downwards, simultaneously press the two retaining clips
(1) and remove the upper edge of the door by pulling it towards
you (2).
TROUBLESHOOTING
Problem
The oven does not work
The display shows the letter "F"
followed by a number
Download the complete Use and Care Guide from www.aristonchannel.com for more informations about your
Policies, standard documentation and additional product information can be found by:
Visiting our website www.aristonchannel.com
•
• Using QR Code
Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
•
contacting our After-sales Service, please state the codes provided on your product's identification
plate.
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the appliance.
~15°
b
a
3
Possible cause
Power cut
Disconnection from the
mains
Software problem
product
for the certification authorities in accordance with the
standards IEC and IEC 60350-1.
Wear protective gloves.
The oven must be disconnected from
the mains before carrying out any
kind of maintenance work.
1
Lift and firmly hold the inner glass with both hands, remove it
and place it on a soft surface before cleaning it (3).
3
To correctly reposition the inner glass, make sure that the "R" is
visible in the left-hand corner and the clear surface (not printed)
is facing up. First insert the long side of the glass indicated by
"R" into the support seats, then lower it into position (4). Refit
the upper edge (5): a click will indicate correct positioning. Make
sure the seal is secure before refitting the door.
4
Solution
Check for the presence of mains electrical power
and whether the oven is connected to the
electricity supply.
Turn off the oven and restart it to see if the fault
persists
Contact you nearest After-sales Service Centre and
state the letter or number that follows the letter "F"
2
5
Model: xxxXXXXxx XXXXXXXXXXXXXX