Descargar Imprimir esta página

Lagrange Glaces Creativ 419 002 Modo De Empleo página 42

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
Glaces Cre?ativ:LAGRANGE
CAUTION :
Never use the removable bowl in a microwave, oven
or any other heating appliance.
The removable bowl is fragile, take care not to scratch
it while cleaning.
Do not put very hot liquid inside the bowl and never
put it under very hot water when it is very cold.
Never operate the appliance without the cover in order
to prevent any loss of refrigeration.
Using the timer
——————————————————
The electronic timer allows you to programme the
O
preparation time.
Important: When the timer goes off the mixing process
O
stops but the refrigeration process continues. Once the
ice cream is ready, the appliance must be put in the
"off" position to turn off the appliance. (the indicator
lamp goes off)
To set the timer, press the "time setting" button several times
O
until the desired time display
Press the "start time" button to start the timer.
O
When the time stops flashing, this shows that the
O
preparation has begun.
If you wish to modify the time, press the "stop time" button
O
and repeat the above operation.
21/01/10
11:12
Page 43
The end of the preparation time will be indicated by an
O
audible signal 30 seconds before the end of preparation.
CAUTION: The signal indicates that the programmed time
O
has elapsed but does not indicate that the ice cream is
ready. If, however, after the end of the time set the ice cream
is not of proper consistency, press the "start time" button to
restart the process for 5 minutes.
Starting
———————————————————————
Before use, prepare your ice cream mixture (see recipes).
If you are using a hot preparation, let it cool in the refrigerator
until the mixture is at the refrigerator's temperature
(about 10°C).
Place the appliance on a flat surface and make sure that the
O
ventilation grilles are not obstructed.
Connect the assembled appliance to the mains
O
Press the cooling On button (located on the motor unit); the
O
indicator light comes on to indicate that the process has
begun.
Wait for 5 minutes then start the blender function by
O
pressing the button located on the blender motor.
Pour out the preparation from the opening of the transparent
O
cover. IMPORTANT: Never put hot food in the bowl.
IMPORTANT: never fill the bowl more than half because
O
the volume increases as the ice cream is made.
41

Publicidad

loading