Publicidad
ITEM
DESCRIPTION
1
Chain pipe cover
2
Pin - spring
3
Pressure finger
4
Spring
5
Base
6
Connection bolt
7
Rope fork
8
Lid cover bolt
9
Key
10
Gypsy shaft
11
Combo shaft
12
Clip - 1
13
Bearing
14
Clip - 2
15
Oil seal
16
Washer
17
Cone clutch
18
Gypsy
19
Gypsy cap
20
Capstan
21
Capstan screw
22
Clutch handle
GB
Anchorlift windlasses are constructed with materials resistant to marine environments
In case, any salt deposits on the outside must be removed periodically to avoid corrosion and damage to the equipment. The part
where salt may have built up should be washed thoroughly with fresh water.
Once a year – the drum and gypsy are to be taken a part as follows.
Drum version:
Use the handle ( 22 ) to loosen the capstan screw ( 21 ), pull off the drum / capstan ( 20 ) and the top clutch cone ( 17
). Loosen the lid cover bolts ( 8 ) on the chain pipe cover ( 1 ) and remove both parts. Pull away the pressure finger ( 3
) from the gypsy ( 18 ) and remove the gypsy.
Low profile version:
Use the handle ( 22 ) to remove the gypsy cap ( 19 ). Remove the the top clutch cone ( 17 ), loosen the lid cover bolts (
8 ) on the chain pipe cover ( 1 ) and remove both parts. Pull away the pressure finger ( 3 ) from the
gypsy ( 18 ) and remove the gypsy.
Clean all the parts removed to avoid corrosion, and grease the shaft ( 10/11 )
and the gypsy ( 18 ) where the clutch cones rest ( 17 ). Use grease suitable for the marine environment
MAKE SURE THE ELECTRICAL POWER TO THE MOTOR IS SHUT OFF WHEN WORKING ON THE WINDLASS. CAREFULLY
REMOVE THE CHAIN OR ROPE FROM THE GYPSY OR THE ROPE FROM THE DRUM.
Maintenance - Entretien - Wartung - Mantenimiento
WARNING
12
.
Publicidad
