Publicidad
Idiomas disponibles
Idiomas disponibles
EN
11
OPERATION
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
11.1
SPECIFIC SAFETY WARNINGS
•
Danger of kickback – Kickback can result in fatal
injuries. Kickback occurs when the cut-off machine is
suddenly thrown up and back in an uncontrolled arc
towards the operator. Refer to the safety section for
detailed information about kickback.
•
Do not stand in line with the abrasive wheel. Ensure
sufficient freedom of movement, especially in
construction trenches there must be sufficient space for
the user and for the part being cut to fall. Do not lean too
far forward and never bend over the abrasive wheel.
•
Frequently inspect the cutting wheel – replace it right
away if there are visible cracks, buckling or other damage
(for example, overheating) – risk of accident or death due
to breakage!
IMPORTANT
WARNING
English
11.2
HOLD THE MACHINE
1. Hold the machine with one hand at the rear handle and
with the other hand at the front handle. Always use both
hands when using the machine.
2. Hold the handles with the thumbs and the fingers around
them.
3. Make sure that the thumb of the hand that holds the front
handle is below the handle.
11.3
START THE MACHINE
1. Press the on/off button (14).
2. Press the lock-out button (3).
3. Press the trigger (4) while you hold the lock-out button.
11.4
STOP THE MACHINE
1. Release the trigger to stop the machine.
11.5
LED LIGHT
The LED light illuminates when the switch is depressed.
It provides extra light for increased visibility.
1. Press the light button (16) to turn on the LED light (17).
10
Publicidad
