Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5. Tightining the screw with 18.5 ft-lbs.
12.2
CLEAN THE MACHINE
•
Remove the battery pack from the machine before
cleaning.
•
Check and clean the magnet filter (18) after every
working shift cutting in metal.
•
Clean the machine after use with a moist cloth dipped in
neutral detergent.
•
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Never clean the battery or the machine with a water hose
or a pressure washer.
13
TRANSPORTATION AND
STORAGE
Before you move the machine, always:
•
Remove the battery pack from the machine.
•
Keep hands clear of the switch.
Before you put the machine into storage, always:
•
Remove the battery pack from the machine.
•
Make sure to clean the machine before storage.
•
Make sure that the storage area is:
•
Not available to children.
•
Away from agents which can cause corrosion, such as
garden chemicals and de-icing salts.
14
TROUBLESHOOTING
Problem
The motor runs but the wheel
does not rotate.
English
Possible cause
The wheel is too loose.
The wheel is damaged and cannot rotate.
The motor is damaged.
12
Solution
Make sure the screw is tightened with correct
torque (See figure 3).
Check the blade guard and remove unwanted
material after that see if the blade runs free.
1. Remove the battery pack from the machine.
2. Remove the wheel.
3. Clean the machine.
4. Install battery pack and operate the machine.
5. Call service center if the fault appears again.
Publicidad
