Publicidad
Idiomas disponibles
Idiomas disponibles
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
WARNING
For your personal safety, do not insert battery before the
tool is assembled completely.
10.2
INSTALL THE WHEEL
CAUTION
Wear adequate clothing, gloves and goggles before touching
the wheel.
CAUTION
The composite abrasive wheel is suitable for steel materials;
the diamond abrasive wheel is suitable for concrete
materials.
WARNING
Note the arrows on the guard indicating the direction of
rotation. Make sure the wheel is fitted in the same direction.
1. Press and hold the spindle lock button (11).
2. Remove the washer (13) and screw (12).
3. Fit the wheel (6), washer (13) and screw (12).
4. Tightining the screw with 18.5 ft-lbs.
English
10.3
ADJUST THE ANGLE OF GUARD
The guard can be adjusted to different angles.
1. Pull the guard adjustment lever (10) rearward and hold it.
2. Move the guard to the desired angle.
3. Release the guard adjustment lever.
10.4
INSTALL THE BATTERY PACK
•
If the battery pack or charger is damaged, replace the
battery pack or the charger.
•
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
•
Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
10.5
REMOVE THE BATTERY PACK
1. Push and hold the battery release button (15).
2. Remove the battery pack from the machine.
9
WARNING
EN
Publicidad
