Publicidad
Idiomas disponibles
Idiomas disponibles
2. It can light up the work area and provide a cutting line.
3. Press the light button again to turn off the LED light.
11.6
FUNCTION OF CONTROL PANEL
ON/OFF button
•
1 push – power on/off.
•
1 minute delay of inactivity – power turns off .
•
If light is on. 1 minute delay of inactivity – stand by.
Light button
•
When power is on 1 push – light on/off .
•
10 minutes delay of inactivity – light turns off .
•
Last minute of delay flashes will occur before light turns
off .
11.7
CONNECT THE WATER SUPPLY
WARNING
Wet cutting is used only with the diamond abrasive wheel
when cuting concrete.
WARNING
Follow the instruction on the cutting equipment before
applying water.
CAUTION
In sub-zero temperature, the water must be drained out from
the pipe after finishing work to avoid the risk of freezing.
1. Assemble the water supply to the connector.
2. Connect coupling (8) to the machine.
3. Adjust the water flow by the adjuster (9). After work,
stop the machine and close the water supply.
NOTE
Do not cut after closing the water supply. The concrete
grout can block the water outlet.
4. Disconnect the water supply from the connector.
English
12
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
12.1
REPLACE THE WHEEL
Use only approved replacement blades.
Wear adequate clothing, gloves and goggles before touching
the wheel.
1. Stop the machine.
2. Press and hold the spindle lock button (11).
3. Remove the wheel (6), washer (13) and screw (12).
The machine applies to two sizes (0.8''/1'') of wheel bore.
You can change to the other size via turning over the shaft
sleeve (19).
4. Fit the new wheel, washer and screw.
11
CAUTION
CAUTION
WARNING
WARNING
CAUTION
NOTE
EN
Publicidad
