Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Auxiliary handle assembly
• For a safer operation use the auxiliary handle. Fit it
into any of the three mounting orifices. Choose the
one that make your job easier.
Start Up
The Angle Grinder is a power tool. It is used to grind and cut steel, pipes, and angles in iron, bricks, tiles, stone and/or
ceramic pieces. Also to remove burr from metal surfaces, to level and smoothing out soldering. When changing the tool
accessory it can be used to clean rust and to buff metal surfaces and other materials.
Turning On
• Turn on the tool sliding the switch lock forward. Slightly press the
switch trigger (A).
• To stop the tool, press and release the switch (B).
Handle rotation
• Regarding the job, the angle grinder handle can be rotated to operate the tool
A
B
more comfortably. Press the handle rotation-blocking button (C). Turn into the
desired position until a "click sound is heard".
C
How to properly hold the tool
Always use the tool with both hands. One hand holds the
handle and the other hand on the auxiliary handle.
Be careful not to obstruct the ventilation slots.
• Grinding:
For better results hold the tool at and angle of 15° to 30°
with regards to the work piece. Move backward and forward
with a constant rhythm and a slight pressure. This way the
work piece will not get too hot, will not fade and will not
have rough edges.
• Cutting:
Do not press, tilt or oscillate the tool. Use a moderate speed.
The disc should always rotate in a movement opposite to the cutting
movement. Never do it the other way around. There is danger the
tool shoots out of control.
For cutting stone we recommend using a diamond disc.
7
ENGLISH
Publicidad
