Descargar Imprimir esta página

Progress Lighting Fresno P2548 Serie Manual De Instalación página 12

Ventilador de techo

Publicidad

Idiomas disponibles

Idiomas disponibles

Automated Learning Process
CAUTION: The remote control transmitter can
be programmed to multiple receivers or fans. If
this is not desired, turn wall switch off to any
other programmable receiver or fan.
This remote control transmitter is equipped with
16 code combinations to prevent possible
interference from or to other remote units such
as garage door openers, car alarms or security
systems. If you find that your fan and light go on
and off without using your remote control,
simply change the combination code in your
remote control transmitter. To set the code,
perform these steps:
1. Remove battery cover from back side of
transmitter.
2. Use a ballpoint pen or a small screwdriver to
set the code switches 1 through 4 for the
transmitter. Note: Since this fan comes with an
LED module, the dimmer switch (labeled D and
X) has been pre-set to the "ON" position (D). If
you do not wish to have dimming capability,
please move the switch to the "OFF" position
(X). (Fig. 15)
9. Operating Your Transmitter
3. Restore electrical power and then set slider switch
on wall control to the ON position. Within 30
seconds of turning on the wall control, press and
hold the "OFF" button on the front of the transmitter
for 5 seconds or until light on fan blinks twice. (Fig.
15)
4. Test the fan and light functions to confirm the
learning process is complete.
Code
Figure 15
1. HI , MED , and LOW buttons:
These three buttons are used to set the fan speed as
follows:
HI = high speed
Med = medium speed
Low = low speed
2. OFF button:
This button turns the fan off.
3.
button:
This button controls the light. Press and release the
button to turn the light ON or OFF. Press and hold the
button to set the desired brightness. The light key has
an auto-resume, it will stay at the same brightness as
the last time it was turned off.
MED
HI
REV
LOW
OFF
Figure 16

Publicidad

loading

Este manual también es adecuado para:

Fresno p2548-0930kFresno p2548-2030kFresno p2548-3030k