Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustments
Variant:
Application for:
Bracket II
manholes
*
= (NW) Nominal width of gripping goods
**
= Tolerance ± 10 mm (± 7/16")
ATTENTION: when gripping manhole basers
Fig. 1A
PROCEDURE
Caution with adjustments at the device, do not grip into moveable parts.
Danger of injury the hands!
•
To adjust the respective nominal width, first remove the safety clips at the socket pin and then pull the socket pin
(Pos.1) out.
•
Position bracket holder (marking) at the respective nominal width (Fig. 2).
•
Insert the socket pin (Pos.1) again into respective hole.
•
Secure socket pin (Pos.1) again with safety clip.
Take notice, that all three brackets are adjusted to the same nominal width.
Slipping danger of gripping good!
54000046
*
NW
(Inner-Ø) mm
1000, 1050, 1200, 1250, 1350, 1500
When gripping manhole bottom parts with
bracket II, bracket III must be moved first into
the "stand-by position"!
Bracket holder
Bracket II
Stand-by position
Bracket III
17 / 29
**
Parkposition „P"
GB
Publicidad
