Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Nominal width 625 - 800 – Bracket III
All three stabilizers of the device must always rest on the upper edge of the gripping good
(manhole/cone)! (see Fig. 4)
As soon as only one of the three stabilizers has a larger distance than 15 mm (between stabilizer lower
edge and gripping good upper edge), it is in no case allowed, to lifted the gripping good !
TIP: Lower the device to the ground and try again.
Otherwise it exists slipping danger of the gripping good!
Upper bracket
(Bracket II)
Lower edge of
upper bracket
Lift the support frame slowly with gripped gripping good and avoid jerky movements!
Never drive with the support frame (excavator) and gripped-load on device
(SVZ-UNI) over uneven area faster than slow walking speed!
6.1.1.1
Manholes (DIN 4034-1 and 2) with total height of 250 mm (10")
When gripping manhole rings with a minimum total height of 250 mm (10")
an accessory must be fitted additionally:
"Adaptor kit for SVZ-UNI" (see Fig. opposite).
Order no.: 4400.0079
Adaptor kit may only be used, when manhole rings with a total height of 250
mm (10") should be installed (and not generally for larger total heights)!
Manholes with a lower total height as 250 mm (10") may not be gripped
and transported!
The griping of manhole rings (total height 250 mm/10") WITHOUT above named accessory
(4400.0079) is prohibited (→ see Fig. 1).
Danger of slipping and not gripping effectively!
54000046
Fig. 4
→
21 / 29
Upper
edege of
gripping
good
Gripping good
(manhole)
GB
Publicidad
