Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
The gripping of shaft cones with a cylindrical
part more than 150 mm (> 150 mm) is not
allowed.
The brackets gripping then, with the lifting in the
cylindrical part of the manhole cover opening
(see Fig.6). The shaft cone hangs thereby a
little diagonal.
Thus it exists slipping danger of the gripping
good!
DANGER OF LIFE!!!
6.1.3 General safety information
When driving over uneven area mind, that the lift arm of the support frame does not begin for hopping!
•
There is the danger that the gripping good (manhole/cone) could break apart by the tension force
(from inside).
•
It exists the danger, that the distance between gripping good (upper edge of manhole) and lower
edge of stabilizer and/or brackets becomes larger that than 15 mm.
In this case lower gripping good on the ground immediately and grip it again.
•
Transport the device (SVZ-UNI) with the gripped gripping good (manhole/cone) to the destination and lower it
carefully.
•
Relieve chain suspension/load hook at support frame (excavator), until load tie rod on device (SVZ-UNI) slips
downward.
•
Move device lifting hook by diagonal pulling of load tie rod in position "release" (Fig. 1).
•
Bring the device (SVZ-UNI) out of the gripping good (manhole).
54000046
Fig 6
24 / 29
GB
Publicidad
