Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustments
5.1.2 Bracket III
Fig. 3
Bracket holder
Variant:
Application for:
Bracket III
manholes / cones
*
= (NW) Nominal width of gripping goods
**
= Tolerance ± 10 mm (± 7/16")
PROCEDURE
Caution with adjustments at the device, do not grip into moveable parts.
Danger of injury the hands!
•
To adjust the respective nominal width, first remove the safety clips at the socket pin and then pull out the socket
pin (Pos.1).
Position bracket holder at the respective nominal width 800 (Fig. 4).
ATTENTION: DO NOT INSERT THE SOCKET PIN IN THE STAND-BY POSITION!
•
Insert the socket pin (Pos.1) again into respective hole.
•
Secure socket pin (Pos.1) again with safety clip.
Bracket II must be moved inwards (see arrow–picture 3)!
Take notice, that all three brackets are adjusted to the same nominal width.
Slipping danger of gripping good!
54000046
Fig. 4
Nominal width
625
Nominal width
Display
Bracket III
Stand-by position
*
NW
(Inner-Ø) mm
**
625 - 800
18 / 29
Pos.
1
800
GB
Publicidad
