Starting And Stopping - Ryobi RY29550 Manual Del Operador

STARTINg AND STOPPINg

See Figures 12 - 14.
When starting the string trimmer for the first time or when
the battery voltage is low, it may be necessary to manually
start the string trimmer.
FOR MANUAL START:
To start a cold engine:
DO NOT squeeze the throttle trigger until the engine starts
and runs.
 Lay the trimmer on a flat, bare surface.
 PRIME - Press the primer bulb 7 times.
 SET the start lever to the START position.
 PULL the recoil starter until the engine starts.
 Wait 6-10 seconds, then squeeze the trigger to run.
NOTE: Squeezing and releasing the throttle trigger releases
the start lever to the RUN position.
To start a warm engine:
 PULL the recoil starter until the engine starts.
To stop the engine:
 Press and hold the switch in the stop "
the engine stops.
OPERATION
FOR ELEcTRIc START:
To start a cold engine:
DO NOT squeeze the throttle trigger until the engine starts
and runs.
 Lay the trimmer on a flat, bare surface.
 PRIME - Press the primer bulb 7 times.
 SET the start lever to the START position.
 PRESS ignition switch.
 RELEASE ignition switch after engine starts.
 Wait 6-10 seconds, then squeeze the throttle trigger to run.
NOTE: Squeezing and releasing the throttle trigger releases
the start lever to the RUN position.
To start a warm engine:
 PRESS ignition switch.
 Lay the trimmer on a flat, bare surface.
 RELEASE ignition switch after engine starts.
" position until
11 — English