NORAUTO N30 Manual De Usuario página 47

The jack does not
reach the maximum
height.
The jack does not
reach the minimum
height.
The jack gets jammed
in a high position
when under load.
After maintenance or repair work, check that all markings are still legible
and identical to the original markings.
DISPOSAL
Dispose of the jack at a recycling centre or a collection point in your city/
municipality.
DISPOSAL OF LUBRICANTS, CLEANING AGENTS, AND USED OIL
IMPORTANT: Lubricants, cleaning agents and used oil from the hydraulic
system must not be disposed of in household waste, in the sewage system
or outdoors!
Dispose of lubricants, cleaning agents and used oil at a recycling centre or
a collection point in your city/municipality.
Warning
Wear work shoes
Secure the load with blocks before starting work on or under the
vehicle.
5. See 2 above.
6. See 4 above.
7. The return spring is weak or not secure.
Grease and clean all moving parts of the lifting
mechanism or replace the return spring.
Release the pressure by loosening the valve with the
supplied lever handle. If the valve cannot be loosened
with the handle, use a wrench (not included).
If the jack cannot be lowered, tighten the valve again
and move the jack up and down 10 times. Then try
to release the pressure again by loosening the valve.
Warning: Avoid loosening the valve for more than
three consecutive cycles.
If the aforementioned measures are ineffective, use
other approved lifting devices to lift the load and
remove the defective jack. Arrange for the jack to be
repaired by a qualified technician.
Use wheel chocks to fix the
vehicle in place.
Use wheel chocks to fix the
vehicle in place.
EN
46