Alemite 586-A Instrucciones De Usuario página 11

Prime gun
In most cases the gun will prime simply by
operating the trigger several times
Should grease fail to appear, air must be
bled
Force prime
This process manually assists air within the
gun to be bled at the bleed valve
1 Pull follower rod and engage follower by
rotating rod
2 Depress bleed valve (45) and at same time
push on follower rod
Once the air is eliminated, operate the gun
several times
Once grease appears, disengage the
follower rod from the follower and push into
the grease cylinder
Check valve contamination
Should the gun fail to prime; the outlet check
may be held open Remove plug (36), clean
ball (38), and the ball seat of head (14)
NOTE
Gun is equipped with software to protect
motor When a blocked bearing, line, or
grease fitting causes gun to stall,
software will cut power to motor
If this situation occurs, release trigger
immediately
For maximum motor life, avoid
operating at stall
Battery and charger safety
This manual contains important safety and
operating instructions for battery part
number 343432 and battery chargers
343500 and 343501
Battery (41) is intentionally shipped with a
low charge Charge battery prior to use
Refer to battery charger operation section
for details
WARNING

Before using battery charger read all
instructions and cautionary markings
on battery charger (42, 43), battery (41),
and products using battery
Do not use extension cord
Do not incinerate battery, even if it is
severely damaged or completely worn
out Battery may explode in fire
Risk of electric shock 120 V AC or
230 V AC present at charfer terminals
Do not expose battery to spark or
flame Battery liquid may burn
Do not splash or immerse in water or
other liquids This may cause premature
cell failure
Never attempt to open battery pack
for any reason If plastic bag of battery
pack breaks or cracks, return to a ser-
vice center for recycling
Failure to comply may result in death
or serious injury
11
CAUTION

Do not expose charger to rain, snow,
or frost
Make sure cord is located so that it
will not be stepped on, tripped over, or
otherwise subjected to damage or
stress
Do not operate charger with damaged
cord or plug Replace immediately
Do not operate charger if it has
received a sharp blow, been dropped, or
otherwise damaged in any way
Do not disassemble charger
Charger is designed to operate on
standard household electrical power
Do not attempt to use it with any other
voltage
Consecutive charging may cause
overheating If you need to recharge
battery consecutively, wait for
15 minutes to allow charger to cool
Do not insert foreign material into slot
for battery in charger stand
Do not disassemble battery
Do not store gun and battery assem-
bly in locations where temperature may
reach or exceed 104° F (40° C)
Do not short-circuit battery
Do not place charger in an area of
extreme heat or cold It works best at
normal room temperature