Alemite 586-A Instrucciones De Usuario página 8

WARNING

Do not use any hose not approved by
Alemite Extreme pressure may cause
nozzle extension or whip hose to burst
Replace hose at first sign of wear,
kinks, or damage to outside jacket
Follow whip hose instructions
and warnings
Failure to comply may result in death
or serious injury
Safety of others
This appliance is not intended for use by
persons with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use of
the appliance by a person responsible for
their safety
Residual risks
Additional residual risks may arise when
using tool that may not be included in
enclosed safety warnings These risks can
arise from misuse, prolonged use, etc
Even with application of relevant safety
regulations and implementation of safety
devices, certain residual risks cannot be
avoided These include:
• Injuries caused by touching any rotating/
moving parts
• Injuries caused when changing any parts,
blades or accessories
• Injuries caused by prolonged use of tool
When using any tool for prolonged periods
ensure regular breaks are taken
• Impairment of hearing
• Health hazards caused by breathing dust
developed when using your tool (example:
working with wood, especially oak, beech
and MDF)
Electrical safety
Your charger is double insulated; therefore
no ground wire is required Always check
that the mains voltage corresponds to the
voltage on the rating plate Never attempt to
replace the charger unit with a regular mains
plug
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised Alemite service centre in order
to avoid a hazard
NOTE
Vibration emission value during actual
use of power tool can differ from
declared value depending on how tool is
used Vibration level may increase above
level stated
Vibration
Declared vibration emission values stated in
technical data and declaration of conformity
have been measured in accordance with a
standard test method provided by
EN 62481 and may be used for comparing
one tool with another
Declared vibration emission value may
also be used in a preliminary assessment
of exposure
When assessing vibration exposure to
determine safety measures required by
2002/44/EC to protect persons regularly
using power tools in employment,
estimation of vibration exposure should
consider actual conditions of use and the
way the tool is used, including taking account
of all parts of operating cycle such as times
when tool is switched off and when it is
running idle in addition to trigger time
8
Labels on
battery charger
The following symbols are shown on tool:
Time-lag miniature
fuze link, 3.15A
IEC
IEEE/ANSI
IEEE/ANSI
The charger is
intended for
indoor use only
WARNING

Do not use tool before reading manual
to reduce risk of injury
Failure to comply may result in death
or serious injury
NOTE
Do not attempt to replace charger unit
with regular main plug Charger is
double insulated and no ground wire is
required Check mains voltage
corresponds to voltage on rating plate
If the supply cord is
damaged, it must be
replaced by the
manufacturer or an
authorized Alemite
service center in order to avoid a hazard