Flex 430005 Instrucciones De Funcionamiento Originales página 18

Removing the accessories
WARNING!
Remove the battery before carrying out any
work on the power tool.
CAUTION!
Used cutting accessories may become hot.
Wear protective gloves!
 Pull the locking sleeve backwards (1.).
 Remove the cutting accessory (2.).
Fitting the three-jaw chuck
NOTE!
To fit a three-jaw chuck you will need the
original adapter from the FLEX accessories
range.
 Screw the three-jaw chuck onto the
adapter (1.).
 Insert the adapter (2.) and turn (3.) until it
locks.
 Check the lock by pulling on the three-
jaw chuck.
CAUTION!
With the three-jaw chuck fitted, never use
chiselling mode
The tool and three-jaw chuck could become
damaged.
18
or hammer drill mode
Direction preselection
CAUTION!
Change the direction of rotation only when
the power tool is stopped.
 Move the direction preselector switch to
the required position:
– Left: counterclockwise (remove screws,
release screws)
– Right: clockwise (drill, insert screws,
tighten down screws)
– Middle: switch-on interlock
(tool change, when working on the
power tool)
Setting the operating mode
CAUTION!
Do not change the operating mode until
the power tool has come to a stop.
 Setting rotary knob to the required
operating mode:
Drilling
Hammer drilling
Setting the chisel position
!
(see below)
Chiselling
CHE 18.0 - EC