User and installation manual WE 30
1.1. Check before taking a sauna bath
1.
The sauna room is suitable for taking a sauna bath.
2.
The door and the window are closed.
3.
The sauna heater is topped with stones that comply with the manufacturer's
recommendations, the heating elements are covered with stones, and the stones
are piled sparsely.
The main switch of the heater is located on the side of the contactor box
The main switch is marked with a 0 – 1 sticker.
1.2. Sauna room
The walls and ceiling of a sauna room should be thermally well insulated. All surfaces
that store heat, such as tiled and plastered surfaces must be insulated. It is
recommended to use wooden panel cladding inside the sauna room. If there are heat
storage elements in the sauna room, such as decorative stone, glass etc., note that
these elements may extend the pre-heating period even though the sauna room is
otherwise well insulated (see page 4, section 1. Preparing for sauna heater installation).
1.3. Operation of the sauna heater controls
This appliance may not be used by children aged less than eight years, by persons with
reduced physical, sensory or mental capabilities, or by persons lacking experience and
knowledge regarding its operation only if such have been given instructions on the safe
use of the device and the risks involved. Children must not be allowed to play with the
appliance or to clean and service it without supervision. (7.12 EN 60335-1:2012)
1.4. Operation of the sauna heater controls
Refer to the specific control panel operating instructions.
Rearrange the sauna stones at least once a year and replace any weathered stones.
This enhances air circulation between the stones, which extends the useful life of the
thermal resistors.
If you encounter any problems, please contact the manufacturer's warranty service shop.
For additional information about enjoying a sauna bath, please visit our website at :
www.Sauna360.com
3